Д¬lient IP Mask - Enter the client IP mask for an SNMP community. Otherwise, this value is ANDed with the mask to determine the range of allowed client IP addresses.Д®quivalent CLI command: snmp-server community ipaddr. A value of 0.0.0.0 allows access from any IP address. The address is the associated community SNMP packet sending address and is used along with the client IP mask to denote a range of IP addresses from which SNMP clients may use that community to access the device. Community names in the SNMP Community table must be unique.Д®quivalent CLI command: snmp-server community where is the community name of the system.Д¬lient IP Address - Enter the client IP address for an SNMP community. SNMP Community Name - Enter a string of 1-16 case sensitive characters. To view SNMP Supported MIBs, from the Navigation menu, select System в†’ SNMP в†’ Supported MIBs.Д®nter/select the following parameters as required:Д¬ommunity - Select existing Public/Private to change parameters or Create to create a new community. Refer to the following in this procedure:

See equivalent CLI commands in SNMP commands under Management commands in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide. If you want to use SNMPv3 you should use the You should use this menu when you are using the SNMPv1 and SNMPv2c protocol. Only those communities with read-write level access will have access to this menu via SNMP. Only the communities that you define will have access to the switch using the SNMPv1 and SNMPv2c protocols. You can change the defaults or add other communities. Public, with 'Read Only' privileges and status set to enable. Private, with 'Read/Write' privileges and status set to enable. You can configure the switch to act as an SNMP agent so that it can communicate with SNMP managers on the network. Use this procedure to configure Simple Network Management Protocol (SNMP) on the switch and enable trap receivers.

Snmp trap receiver gui